If you don't use the engine ported vacuum switch then the wire from terminal D should be grounded at all times. I used a radio shack LED and since it wasn't for 12 volts I run a resistor in series with it to drop the voltage. To submit your questions or ideas, or to simply learn more about It Still Runs, contact us. Install and torque the flywheel to converter bolts to 46 foot pounds. However, the first thing you always should to when your transmission is slipping is to replace the transmission fluid and to flush the transmission. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. I have a picture of it but not sure how I could send it to you.
I have also added a page that goes into a lot better detail on how to setup the carb for the TV cable and how to make a mount for the housing end of the TV cable.
What’s Needed to Install a 700-R4 or 4L60E Trans Behind Carbureted 350?
This time, I will use an electronic speedo. If you are looking for either just any parts for your r4 transmission or are looking for a brand new transmission, I can recommend you to check it out on Amazon if you live in the USA or Europe. Step 2 Position the transmission against the rear of the engine. Thank you for taking the time to share!! And after a half mile it started doing the same thing again.